# [riot-notifications] [RIOT-OS/RIOT] boards/esp32 wrover kit: documentation fixes and small improvents (#11481)

Thu May 9 09:17:43 CEST 2019

leandrolanzieri commented on this pull request.

> @@ -92,7 +93,7 @@ ESP-WROVER-KIT has the following on-board components

The following table shows the default board configuration sorted according to the defined functionality of GPIOs for different hardware options. This configuration can be overridden by \ref esp32_app_spec_conf "application-specific configurations".

-In the following table following abbreviations are used:
+The following abbreviations are used in following tables:

"Abbreviations used in the following tables:"?

> @@ -247,7 +248,7 @@ The USB bridge is based on FDI FT2232HL and offers two USB interfaces:
- the first interface is the JTAG interface for [On-Chip debugging](#debugging)
- the second interface is the console interface, which is also used for flashing

-Therefore, you have to declare the USB interface in the make command. For example, if the ESP32-WROVER-KIT is connected to the host computer through the USB interfaces **/dev/ttyUSB0** and **/dev/ttyUSB1**, the make command would be used as following:
+Therefore, you have to declare the USB interface in the make command. For example, if the ESP32-WROVER-KIT is connected to the host computer through the USB interfaces /dev/ttyUSB0 and /dev/ttyUSB, the make command would be used as following:

Should this say "... through the USB interfaces /dev/ttyUSB0 and /dev/ttyUSB1..."?

--
You are receiving this because you are subscribed to this thread.
Reply to this email directly or view it on GitHub:
https://github.com/RIOT-OS/RIOT/pull/11481#pullrequestreview-235431288
-------------- next part --------------
An HTML attachment was scrubbed...