[riot-notifications] [RIOT-OS/RIOT] b/c/particle-mesh: Switch default stdio to USB (#15394)
notifications at github.com
Fri Nov 6 15:07:36 CET 2020
I can't test it, but with any other programmer it should work almost the same. The difference is that the `usb_board_reset` module is not built for that, so the `bootloader` command won't be available on the shell and the 1200baud reset trick will not work. (Which is kind of to be expected as there *is no* reboot into the bootloader).
It may be that the `tools/usb_board_reset.mk` include still runs when using the DAPLink programmer, but it doesn't do any harm in stopping the flashing process, and the DAPLink programmer can as always pull the device into reset on its own.
Then, the program runs as it always did, but the serial USB interface comes up, and there's no need to wire a dedicated USB UART to the RX/TX pins. (Or does the DAPLink come with a USB serial interface? In that case, that'd be ignored).
You are receiving this because you are subscribed to this thread.
Reply to this email directly or view it on GitHub:
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the notifications